My friend has has the 3 rollor bearings in the starter motor fail, I think they are in the rear housing ( item 4 on service manual, page 314 section 7 - 20 )
Does anyone know the size of the bearings required as the original one's have fell apart!!
Thanks
Hoover
URGENT STARTER MOTOR HELP REQUIRED
-
Topic author - Beiträge: 19
- Registriert: Sonntag 10. April 2011, 20:13
- Wohnort: Ilkeston,Derbyshire, England
- Kontaktdaten:
-
- Beiträge: 280
- Registriert: Sonntag 25. März 2012, 16:42
- Vorname: Ade
- Wohnort: Sheffield, South Yorkshire, England
- Alter: 74
Re: URGENT STARTER MOTOR HELP REQUIRED
Hoover
If you take both the inner and outer races to a good industial bearing supplier they will be able to measure or identify the bearings from the markings on the inner/outer races. These bearings are unlikely to be close tolerance so there is probably a standard industrial item on the shelf at factory prices.
Hope this helps.
PS These shops are also a good source for oil seals too (seals have all the identification information needed stamped into the rubber lip).
Ade
If you take both the inner and outer races to a good industial bearing supplier they will be able to measure or identify the bearings from the markings on the inner/outer races. These bearings are unlikely to be close tolerance so there is probably a standard industrial item on the shelf at factory prices.
Hope this helps.
PS These shops are also a good source for oil seals too (seals have all the identification information needed stamped into the rubber lip).
Ade